When I see old sweaters at yard sales I have to buy them. The fact that yard sales in my area are often held when the temperature is over 100 means sweaters are practically given away. These sweaters are a cheap craft resource for holiday crafts. In my opinion, this Christmas stocking design looks much more upscale than the original sweater it came from. Can’t you just see a bunch of these hanging over a cabin fireplace, or down the rail of a pine garland clad staircase? Depending on the size of the sweater and the size of your stocking pattern, you should be able to get at least two stockings from each sweater. Three, if you open the sleeves and use the cuffs as the top edge.
Things You Will Need:
2-inch pompoms (two)
Hot glue gun
Turn an adult-size sweater wrong side out and lay it on your work surface. Align the bottom edges of the sweater. Place an existing Christmas stocking, or a paper stocking pattern on the sweater. Align the top edge of the stocking shape (pattern) with the bottom edges of the stocking. Pin the pattern through both layers of the sweater. Cut around the pattern. Note: The top of the stocking (bottom edge of the sweater) is not to be cut. It will be the finished edge for the the top opening of the stocking.
Remove the pattern. Pin the side and bottom edges of the sweater stocking shape together. Sew the pinned edges using a straight stitch and a 1/4-inch seam allowance. Sew around the edges once again using a zigzag stitch on the seam allowance. This will finish the raw edges and prevent the knitted stitches from unraveling. Turn the stocking right side out. Press the seams with a warm iron.
Lay the stocking flat on your work surface. Measure across the width of the stocking at its widest point. Double that and add 24 inches. Using your new measurement, cut a length of rickrack in a color that coordinates with your sweater.
Measure 1 inch down from the top edge of your stocking. Starting on the front seam of the stocking and 12 inches from one end of the rickrack, pin the rickrack around the stocking. The rickrack will meet again on the front seam of the stocking. Both ends of the rickrack will have approximately 12 inches extending. These tails will be ties. Top stitch the pinned rickrack around the stocking.
Tie the rickrack tails in a knot against the seam, then tie into a bow. Trim the tails to the desired length.
Burrow a hole on one side of a 2-inch diameter pompom. Apply hot glue in the hole. Place one end of the rickrack in the glue. Squeeze the edges of the pompom hole around the rickrack end. Repeat with the remaining pompom and and rickrack end.
Cut a 5-inch length of rickrack. Fold the rickrack in half, matching the two cut ends. Place the ends inside the stocking, against the back seam. Sew across the cut ends of the rickrack. This is your stocking’s hanger.
Other trims and tassels handmade with yarn can be substituted.